Currently Viewing Posts Tagged Tile Installation

Great Concept of Tile Installation Portland Oregon

With the shower pan, I began tiling where I could lap over layout cuts with complete wall tiles at the perimeter. Installing a square drain cover helped encourage tile cuts and complemented the theme of the square tile. To boost bond and flexural strength, I used Mapei Kera bond # 102 white dry-set mortar with non-diluted Kerala tic # 310 liquid acrylic latex admixture. I deeply enjoyed this demanding installation ‘s long opening period. I applied the thinnest using the flat side of a trowel and then raked it with a 3/16″x1/4 “V-notched trowel to assess the setting bed ‘s proper width. Then I again used the flat side of the trowel to flatten notch lines and decrease the likelihood of air pockets or voids, resulting in a 1/8 “thick consistent setting bed.Get the facts about Tile Installation Portland Oregon
The shower pan, seat, walls, and ceiling tile mosaic sheets were then applied to the setting bed with brown face paper outward, using light and even pressure to create contact with the setting bed and remove voids. Then a 3/4 “plywood beating block was gently tapped with a hammer to achieve a smooth finish surface. I worked rapidly to apply subsequent sheets with matched grout joints to prevent the setting bed from being skinned and to unify the overall tile surface with the beating stone. I gently misted the brown backing paper with a household spray bottle several times after 15-20 minutes of setting time, patting it with a sponge, using a water mixture and a small amount of DIF wallpaper remover. The glue is removed from the paper after the water has been absorbed into the paper, allowing the paper to be carefully and slowly peeled away to the side without removing the tiles. Paper removal timing was crucial not to take out tiles while making tile spacing changes in the semi-fresh / flexible state of the setting bed at the same time. Before the final package, careful attention was paid to make grout joints changes look random to remove the sheet pattern between individual tiles and adjacent paper sheets. I will eventually remove them, scrape out the thinnest behind, then reattach with some fresh thinnest. Some individual tiles might fall over time. Where possible, I also used some plastic tile spacer wedges.

  • Categories

  • Recent Posts

  • August 2021
    M T W T F S S
  • Ad